Beefy Boxes and Bandwidth Generously Provided by pair Networks
Do you know where your variables are?
 
PerlMonks  

Re^2: perl for HP NonStop

by andreas1234567 (Vicar)
on Sep 22, 2011 at 07:06 UTC ( #927279=note: print w/replies, xml ) Need Help??


in reply to Re: perl for HP NonStop
in thread perl for HP NonStop

I don't have access to Nonstop hardware. I'm just asking if it is theoretically possible to run (any recent) perl on it.

--
No matter how great and destructive your problems may seem now, remember, you've probably only seen the tip of them. [1]

Log In?
Username:
Password:

What's my password?
Create A New User
Node Status?
node history
Node Type: note [id://927279]
help
Chatterbox?
[stevieb]: choroba my GPS home device is done, at least prototype v1 is. I'm just making sure all of my code does what it says now
[stevieb]: I test/prototype code on my Pi, then I migrate it over to Arduino when it's ready (if that's a better platform for what I'm doing). The whole RPi stuff was for learning at first, then it snowballed. I'm just trying to get my in-house CI...
[stevieb]: ...done, which obviously requires a specific hardware setup.
[stevieb]: I don't write tests for the lower-level distributions (ie. ICs, sensors etc) within those distributions, I have all tests in a master distribution which encompasess all of the sub-modules

How do I use this? | Other CB clients
Other Users?
Others meditating upon the Monastery: (6)
As of 2017-06-25 22:54 GMT
Sections?
Information?
Find Nodes?
Leftovers?
    Voting Booth?
    How many monitors do you use while coding?















    Results (572 votes). Check out past polls.