Please consider using code tags instead of formatting the code yourself.
That aside, it looks like it might be a compiler mismatch problem. Earlier in your make output, it mentions:
Your perl and your Config.pm seem to have different ideas about the
architecture they are running on.
Perl thinks: PerlGcc
Config says: sun4-solaris-64int
This may or may not cause problems. Please check your installation of
if you have problems building this extension.
Then, later, when trying to run, you get "fatal relocation errors". I'm guessing that the API differences in the two different compilers may be giving you your problems.
When your only tool is a hammer, all problems look like your thumb.
Posts are HTML formatted. Put <p> </p> tags around your paragraphs. Put <code> </code> tags around your code and data!
Read Where should I post X? if you're not absolutely sure you're posting in the right place.
Please read these before you post! —
Posts may use any of the Perl Monks Approved HTML tags:
You may need to use entities for some characters, as follows. (Exception: Within code tags, you can put the characters literally.)
- a, abbr, b, big, blockquote, br, caption, center, col, colgroup, dd, del, div, dl, dt, em, font, h1, h2, h3, h4, h5, h6, hr, i, ins, li, ol, p, pre, readmore, small, span, spoiler, strike, strong, sub, sup, table, tbody, td, tfoot, th, thead, tr, tt, u, ul, wbr
Link using PerlMonks shortcuts! What shortcuts can I use for linking?
See Writeup Formatting Tips and other pages linked from there for more info.
| & || & |
| < || < |
| > || > |
| [ || [ |
| ] || ] ||