I was going to try and test Gtk2::TrayIcon. I went to install the module and recieved this error:
CPAN.pm: Going to build T/TS/TSCH/Gtk2-1.145.tar.gz
*** can not find package gtk+-2.0 >= 2.0.0
*** check that it is properly installed and available in PKG_CONFIG_PA
+TH
at Makefile.PL line 67
Warning: No success on command[/usr/bin/perl Makefile.PL INSTALLDIRS=s
+ite]
TSCH/Gtk2-1.145.tar.gz
/usr/bin/perl Makefile.PL INSTALLDIRS=site -- NOT OK
Running make test
Make had some problems, won't test
Running make install
Make had some problems, won't install
Failed during this command:
TSCH/Gtk2-1.145.tar.gz : writemakefile NO '/usr
+/bin/perl Makefile.PL INSTALLDIRS=site' returned status 2304
I believe that Gtk2 is installed since I have ran programs that used it before. Any ideas on how to fix this?
-
Are you posting in the right place? Check out Where do I post X? to know for sure.
-
Posts may use any of the Perl Monks Approved HTML tags. Currently these include the following:
<code> <a> <b> <big>
<blockquote> <br /> <dd>
<dl> <dt> <em> <font>
<h1> <h2> <h3> <h4>
<h5> <h6> <hr /> <i>
<li> <nbsp> <ol> <p>
<small> <strike> <strong>
<sub> <sup> <table>
<td> <th> <tr> <tt>
<u> <ul>
-
Snippets of code should be wrapped in
<code> tags not
<pre> tags. In fact, <pre>
tags should generally be avoided. If they must
be used, extreme care should be
taken to ensure that their contents do not
have long lines (<70 chars), in order to prevent
horizontal scrolling (and possible janitor
intervention).
-
Want more info? How to link
or How to display code and escape characters
are good places to start.
|