You need to use Exporter and set it up so that &check is exported, and thus can e used in the script or modules that uses it.
Update: MidLifeXis++ pointed out that it's a fully qualified call that goes wrong, so Exporter is likely not the solution.
From the code you have shown I can't figure out what's wrong. But since the code you did show has so many errors (missing semicolon all over), I'd guess that the most likely cause is a mis-spelled package name. If that's not the case, please reduce your problem to a few lines in each file, and post the complete (reduced) code that shows your code.
Posts are HTML formatted. Put <p> </p> tags around your paragraphs. Put <code> </code> tags around your code and data!
Read Where should I post X? if you're not absolutely sure you're posting in the right place.
Please read these before you post! —
Posts may use any of the Perl Monks Approved HTML tags:
You may need to use entities for some characters, as follows. (Exception: Within code tags, you can put the characters literally.)
- a, abbr, b, big, blockquote, br, caption, center, col, colgroup, dd, del, div, dl, dt, em, font, h1, h2, h3, h4, h5, h6, hr, i, ins, li, ol, p, pre, readmore, small, span, spoiler, strike, strong, sub, sup, table, tbody, td, tfoot, th, thead, tr, tt, u, ul, wbr
Link using PerlMonks shortcuts! What shortcuts can I use for linking?
See Writeup Formatting Tips and other pages linked from there for more info.
| & || & |
| < || < |
| > || > |
| [ || [ |
| ] || ] ||