good chemistry is complicated,
and a little bit messy -LW
Automating System Administration with Perlby clp (Friar)
|on Aug 21, 2009 at 06:55 UTC||Need Help??|
Item Description: Solving problems with a wide variety of Perl modules (as of 2009) by an expert guide to CPAN; focused on multiplatform system admin tasks, and applicable to many other areas.
Review Synopsis: Highly recommended for System Admins and Perl hackers in general.
Automating System Administration with Perl,
By David N. Blank-Edelman
Published May, 2009 by O'Reilly.
Perl for System Administration
The first edition (published in 2000) was titled
The second edition has 50% more pages, four more chapters, and two more appendices.
Table of Contents
Code was tested by the author with Perl 5.8.8 and ActivePerl (5.8.8) 822.
Code was built with 'use strict', but that is not shown in samples.
This is a brief review, based on scanning through the book and reading two chapters and several other sections. I have used the first edition, and was pleased to find that it was revised and expanded to include more data about more modern Perl modules.
This book provides in-depth coverage of how to automate several aspects of SA work with Perl. At one level, it is a tour of a wide variety of CPAN modules for the busy SA, by a very experienced and knowledgeable guide.
The author provides much experience-based data concerning the problems being solved and various Perl modules and techniques that can be employed. The data in this book can help you to avoid expensive mistakes; or at least be prepared to handle such issues.
For example, the section on page 507 points out some benefits of using GD::Graph, and also a possible drawback, ie, it requires multiple levels of dependencies to be built and installed.
To avoid this issue,
he offers several alternatives,
The author follows this paradigm throughout the book:
describing a problem
and a range of tools that can be used
to solve it,
and going into
enough depth so that you can make an informed
where to spend your time when faced with
a similar problem:
Another example: in Chapter 13, he chooses nemesis as a network packet builder. He mentions several alternative tools and also lists the reasons for his choice: the package has been well-maintained and has good multiplatform support. However, it relies on libnet 1.0.2, an older release that might not be on your system. You might have to handle this configuration problem before being able to use the tool. The note includes a link to a web page that covers the issue.
The end of each chapter contains a list of the Perl modules that were covered, and an annotated bibliography of relevant documents and web pages.
The seven appendices, are short tutorials with basic data about some of the technologies used in the book. These are valuable if you are new to the topic, or if you have not worked in that area recently.
There are many gems of insight throughout the book, especially in the highlighted sidebars, notes, warnings, and even footnotes, eg, "Friends don't let friends use Access as a multiuser database." p.75.
I only found one possible typo in my reading, and there was only one errata noted at the publisher's site for the book.
I can offer one suggestion: emphasize the valuable sidebars. They often give a flavor of the issues that you might face when working with the technology being described. Some of the sidebar titles are relevant, while others are not descriptive of the content. Rename the titles that need it, and list all the titles in the table of contents.
The author seems to enjoy writing, and he does it well. There is more than a little humor, which appears natural and not contrived. The technical content here is wide and deep, and is presented effectively.