Not sure what happened. My last post didn't show up (an empty slot for it did though - which is kind of strange). So, I will repeat my comments.
Unless there is some way of excluding modules from ugrading when executing the upgrade command, I can't just ignore the B::C problem. I have set halt_on_failure so any installs I make don't continue if a dependent module fails to build. So, I can't complete the upgrade until I figure out how to get past the B::C upgrade problem
-
Are you posting in the right place? Check out Where do I post X? to know for sure.
-
Posts may use any of the Perl Monks Approved HTML tags. Currently these include the following:
<code> <a> <b> <big>
<blockquote> <br /> <dd>
<dl> <dt> <em> <font>
<h1> <h2> <h3> <h4>
<h5> <h6> <hr /> <i>
<li> <nbsp> <ol> <p>
<small> <strike> <strong>
<sub> <sup> <table>
<td> <th> <tr> <tt>
<u> <ul>
-
Snippets of code should be wrapped in
<code> tags not
<pre> tags. In fact, <pre>
tags should generally be avoided. If they must
be used, extreme care should be
taken to ensure that their contents do not
have long lines (<70 chars), in order to prevent
horizontal scrolling (and possible janitor
intervention).
-
Want more info? How to link
or How to display code and escape characters
are good places to start.
|