|laziness, impatience, and hubris|
Why don't perl one-liners work on my DOS/Mac/VMS system?by faq_monk (Initiate)
|on Oct 13, 1999 at 02:56 UTC||Need Help??|
Current Perl documentation can be found at perldoc.perl.org.
Here is our local, out-dated (pre-5.6) version:
The problem is usually that the command interpreters on those systems have rather different ideas about quoting than the Unix shells under which the one-liners were created. On some systems, you may have to change single-quotes to double ones, which you must NOT do on Unix or Plan9 systems. You might also have to change a single % to a %%.
# Unix perl -e 'print "Hello world\n"'
# DOS, etc. perl -e "print \"Hello world\n\""
# Mac print "Hello world\n" (then Run "Myscript" or Shift-Command-R)
# VMS perl -e "print ""Hello world\n"""
The problem is that none of this is reliable: it depends on the command interpreter. Under Unix, the first two often work. Under DOS, it's entirely possible neither works. If 4DOS was the command shell, you'd probably have better luck like this:
perl -e "print <Ctrl-x>"Hello world\n<Ctrl-x>""
Under the Mac, it depends which environment you are using. The MacPerl shell, or MPW, is much like Unix shells in its support for several quoting variants, except that it makes free use of the Mac's non-ASCII characters as control characters.
There is no general solution to all of this. It is a mess, pure and simple. Sucks to be away from Unix, huh? :-)
[Some of this answer was contributed by Kenneth Albanowski.]