Sorry if my tone offended. It's just that I've been burned enough times by hardware kludges, I tend to mount the soapbox when I see others toying with the same fate. Especially since you indicate it's not a one-off project, I still maintain it's worth the time to figure out what's going on and get it right.
I confess confusion now regarding the separation/non-separation of the RD and SEND lines. I'd be happy to provide more assistance if I knew more about the circuitry of your RS232 converter. Unfortunately, this goes outside the realm of Perl, so this probably isn't the best forum to continue the discussion. Perhaps you could message me on the Chatterbox with your email address, and we could continue there.
-
Are you posting in the right place? Check out Where do I post X? to know for sure.
-
Posts may use any of the Perl Monks Approved HTML tags. Currently these include the following:
<code> <a> <b> <big>
<blockquote> <br /> <dd>
<dl> <dt> <em> <font>
<h1> <h2> <h3> <h4>
<h5> <h6> <hr /> <i>
<li> <nbsp> <ol> <p>
<small> <strike> <strong>
<sub> <sup> <table>
<td> <th> <tr> <tt>
<u> <ul>
-
Snippets of code should be wrapped in
<code> tags not
<pre> tags. In fact, <pre>
tags should generally be avoided. If they must
be used, extreme care should be
taken to ensure that their contents do not
have long lines (<70 chars), in order to prevent
horizontal scrolling (and possible janitor
intervention).
-
Want more info? How to link
or How to display code and escape characters
are good places to start.
|