Note: this reply is mainly going to be a redirect to a new node that takes the discussion from this point. Expect an update soon. Withhold critical judgement until then, please.
sundialsvc4 wrote (the quotations may be slightly adjusted to add my emphasis or to enhance clarity if I thought it could be improved):
I have a few particular cases where the “won’t install without”
scenario appears in some of the deployments that I maintain:
One package requires a third-party C library, a standard one, but it assumes that the library exists. (Perhaps this is because there is no one single known-good way to check for it on all systems?) If it’s not there, you don’t get a prerequisite-error: you get a nasty failure to compile, with lots of oily parts on the runway when the whole thing finally skids to a stop on the tarmac.
Another package is similar: the library has been updated and the package requires the newer one, but older deployments of it do exist out there.
“Missing and unrealized prerequisites,” by-the-by, are a definite possibility
to be dealt-with in the field.
As to the last, certainly, they are. But as an overall generalization this is
far less likely when using the cpan clients to install modules. The clients prompt
the user when installation of the module with unfulfilled prereqs has been
requested. Not to belabor the point but this is not how the OP reported
the pattern of events. No mention was made of cpan prompting her as Makefile was
built-which is long before cpan states (after the test run) that it won't install without force.
These are good points and are scenarios that are familiar to many Perlmonks.
The 2 selected statements are both about external dependencies (where “external”
in this context means provisioned from outside the CPAN installer
universe). Such being the case, and knowing how sticky this whole area can
be, I've created a new node  in which to carry on this discussion. The focus of the
new write-up will be that indicated by sundialsvc4's speculation Perhaps this is
because there is no one single known-good way to check for it on all
Updated 2013-03-23 GMT
Posts are HTML formatted. Put <p> </p> tags around your paragraphs. Put <code> </code> tags around your code and data!
Read Where should I post X? if you're not absolutely sure you're posting in the right place.
Please read these before you post! —
Posts may use any of the Perl Monks Approved HTML tags:
Outside of code tags, you may need to use entities for some characters:
- a, abbr, b, big, blockquote, br, caption, center, col, colgroup, dd, del, div, dl, dt, em, font, h1, h2, h3, h4, h5, h6, hr, i, ins, li, ol, p, pre, readmore, small, span, spoiler, strike, strong, sub, sup, table, tbody, td, tfoot, th, thead, tr, tt, u, ul, wbr
Link using PerlMonks shortcuts! What shortcuts can I use for linking?
See Writeup Formatting Tips and other pages linked from there for more info.
| & || & |
| < || < |
| > || > |
| [ || [ |
| ] || ] ||