Re^5: x.25 with perl

Hello again:

Yes, I am plan to tunnel IP via X.25. As your info, our server will connect into cisco router and the cisco router will connect into X.25 protocol to communicate with the swicthes. So, I plan to develop a perl program to collect files from the swicthes to our server via the connection.

If you are tunneling IP over X.25 as you answered above, your switches will have to have IP addresses. FTP is part of the TCP/IP stack and should be available for copying your files. I think you need to discuss these transport issues with your network engineer or Cisco rep. Or google "Cisco 9362" for a document that describes TCP/IP over X.25. It contains a nice diagram of what I think you are wanting to do.

What type of switch are you wanting to connect to? There could be more specific information on that topic on the Cisco site.

James

There's never enough time to do it right, but always enough time to do it over...

Comment on Re^5: x.25 with perl

Replies are listed 'Best First'.
Re^6: x.25 with perl by bh_perl (Monk) on Apr 30, 2013 at 07:53 UTC
hi... My server will connect to neax switch through cisco router. Please share if you have some guideline about it Thank you	[reply]
Re^7: x.25 with perl by jmlynesjr (Deacon) on Apr 30, 2013 at 18:13 UTC
I didn't find any good information on the NEAX switches. Is there a router at each switch or are all switches connected to one router over individual X.25 circuits? I saw where cisco can assign an X.121 address to a router port. Are you actually wanting to transfer files or do you have to interface to some message based interface on the switch? What software is on the switch to do this? James There's never enough time to do it right, but always enough time to do it over...	[reply]
Re^8: x.25 with perl by bh_perl (Monk) on May 05, 2013 at 14:09 UTC
hi Each neax switch connected to individual cisco router. One router for one neax swicth. I want to transfer file only from the neax switch to our server Thank you very much for your reply	[reply]
Re^9: x.25 with perl by jmlynesjr (Deacon) on May 07, 2013 at 00:48 UTC
Re^10: x.25 with perl by bh_perl (Monk) on May 16, 2013 at 15:09 UTC
Some notes below your chosen depth have not been shown here


Clear questions and runnable code get the best and fastest answer
	PerlMonks