I can confirm, that, using "fresh/clean" Strawberry Perl 188.8.131.52 -- i.e. your version -- the installation of IO::Async fails. That's not the case with Strawberry Perl 184.108.40.206 though, where IO::Async installs OK.
To follow AM's advice, upgrading Socket issuing cpanm Socket under 220.127.116.11 did fix the issue.
I see, however, that
t\70future-io.t .............. skipped: Future::IO is not available
in my case, but not in yours. How come this distribution was installed at your side? It's not required for IO::Async (nor Future, etc.) and its pod says it can be problematic with Win32. I'd suggest to uninstall it, or at least to backup/rename ImplBase.pm, to allow "clean" (i.e. unenforced) IO::Async installation.
Are you posting in the right place? Check out Where do I post X? to know for sure.
Posts may use any of the Perl Monks Approved HTML tags. Currently these include the following:
<code> <a> <b> <big>
<blockquote> <br /> <dd>
<dl> <dt> <em> <font>
<h1> <h2> <h3> <h4>
<h5> <h6> <hr /> <i>
<li> <nbsp> <ol> <p>
<small> <strike> <strong>
<sub> <sup> <table>
<td> <th> <tr> <tt>
Snippets of code should be wrapped in
<code> tags not
<pre> tags. In fact, <pre>
tags should generally be avoided. If they must
be used, extreme care should be
taken to ensure that their contents do not
have long lines (<70 chars), in order to prevent
horizontal scrolling (and possible janitor
Want more info? How to link or
or How to display code and escape characters
are good places to start.