comment on

The first one (9.3333 -> 9.34) is a typo in the original.
The second and third one are easily explained by the following
```
printf("%.15f", 9.55);   # prints 9.550000000000001
printf("%.15f", 43.55);   # prints 43.549999999999997
[download]
```
This means that due to the limitations of the internal representation, the literal 9.55 is in fact 9.550000000000001 which rounds to 9.56. The same goes for 43.55 but there the representation is slightly smaller than 43.55 so a rounding down occurs.

-- Hofmator

In reply to Re: Re: Using (s)printf() by Hofmator
in thread Using (s)printf() by reptile

Posts are HTML formatted. Put <p> </p> tags around your paragraphs. Put <code> </code> tags around your code and data!

Titles consisting of a single word are discouraged, and in most cases are disallowed outright.

Read Where should I post X? if you're not absolutely sure you're posting in the right place.

Please read these before you post! —

Posts may use any of the Perl Monks Approved HTML tags:

a, abbr, b, big, blockquote, br, caption, center, col, colgroup, dd, del, div, dl, dt, em, font, h1, h2, h3, h4, h5, h6, hr, i, ins, li, ol, p, pre, readmore, small, span, spoiler, strike, strong, sub, sup, table, tbody, td, tfoot, th, thead, tr, tt, u, ul, wbr

You may need to use entities for some characters, as follows. (Exception: Within code tags, you can put the characters literally.)

	For:		Use:
	&		`&`
	<		`<`
	>		`>`
	[		`[`
	]		`]`

Link using PerlMonks shortcuts! What shortcuts can I use for linking?

See Writeup Formatting Tips and other pages linked from there for more info.


The stupid question is the question not asked
	PerlMonks